Model No. N300RT (Firmware V2.1.6)
192.168.1.10
e4246cd3d070
Setup Wizard
The setup wizard will guide you to configure access point for first time. Please follow the setup wizard step by step.
Welcome to Setup Wizard. The Wizard will guide you the through following steps. Begin by clicking on Next.
Auto Mode:
Operation Mode
You can setup different modes to LAN and WLAN interface for NAT and bridging function.
Gateway:
In this mode, the device is supposed to connect to internet via ADSL/Cable Modem. The NAT is enabled and PCs in four LAN ports share the same IP to ISP through WAN port. The connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client, L2TP client or static IP.
Bridge:
In this mode, all ethernet ports and wireless interface are bridged together and NAT function is disabled. All the WAN related function and firewall are not supported.
Wireless ISP:
In this mode, all ethernet ports are bridged together and the wireless client will connect to ISP access point. The NAT is enabled and PCs in ethernet ports share the same IP to ISP through wireless LAN. You must set the wireless to client mode first and connect to the ISP AP in Site-Survey page. The connection type can be setup in WAN page by using PPPOE, DHCP client, PPTP client, L2TP client or static IP.
2. Time Zone Setting
You can maintain the system time by synchronizing with a public time server over the Internet.
Enable NTP client update
Automatically Adjust Daylight Saving
Time Zone Select :
NTP server :
131.188.3.220 - Europe
130.149.17.8 - Europe
203.117.180.36 - Asia Pacific
LAN Interface Setup
This page is used to configure the parameters for local area network which connects to the LAN port of your Access Point. Here you may change the setting for IP addresss, subnet mask, DHCP, etc..
PPPoE
PPTP
L2TP
PIN:
APN:
Dial Number:
Attain DNS Automatically
Set DNS Manually
DNS
Select Wireless Band
You can select Wireless Band.
Wireless Band:
IPTV TAG
TAG
IPTV VID
Internet VID
LAN1
LAN2
LAN3
LAN4
TKIP
AES
TKIP
AES
1. WAN Interface Setup
This page is used to configure the parameters for Internet network which connects to the WAN port of your Access Point.
WAN Access Type:
PPPoE
PPTP
L2TP
DNS :
Select Wireless Band
You can select Wireless Band.
Wireless Band:
Set Wireless Network Name
You can enter the Wireless Network Name of AP.
ssss
Select Wireless Security Mode
This page allows you setup the wireless security. Turn on WEP or WPA by using Encryption Keys could prevent any unauthorized access to your wireless network.
:
None
WEP
WPA
WPA2
Key Length
64-bit
128-bit
Key Format
ASCII
Hex
Pre-Shared Key Format:
Passphrase
Hex (64 characters)
Pre-Shared Key:
Authentication Mode:
Enterprise (AS Server)
Personal (Pre-Shared Key)
Pre-Shared Key Format:
Passphrase
HEX (64 characters)
Pre-Shared Key:
AS Server IP Address:
Select WAPI certificate:
Use Cert from Remote AS0
Use Cert from Remote AS1
:
None
WEP
WPA
WPA2
Key Length:
64-bit
128-bit
Key Format:
ASCII
Hex
Pre-Shared Key Format:
Passphrase
Hex (64 characters)
Pre-Shared Key:
Copyright(C)2016 TOTOLINK Ltd., All Rights Reserved